4
Quantum II RFID ECU
PK3724_T 05-19
3 Installing the ECU
1. Determine the reader configuration (Flush or Sur-
face Mount). Refer to Figures 2 and 3.
2. Determine the position of the ECU on the face of
the elevator panel. Be sure there is adequate space
on the face and behind the panel for all mounting
hardware and PCB.
3. Select appropriate template for the reader config-
uration (Page 5 and 6). Use the template to prep
the elevator panel.
Flush mount reader installation
1. Disassemble the reader from the 4 ½ X 4 ½ mount-
ing plate. Refer to the exploded diagram Figure 1.
2. Retain all of the mounting hardware, brackets, and
ECU PCB for re use.
3. Insert the reader through the elevator panel cut
out (Flush mount prep) and re assemble the PCB
mounting bracket onto the back side of the eleva-
tor panel using the mounting hardware.
4. Re install the ECU PCB onto the bracket using the
tie wrap to secure.
(Refer to the exploded diagram Figure 1)
Surface mount reader installation
1. Insert the ECU assembly through the elevator pan-
el cut out (Surface mount prep) and secure it with
four (4) #6 screws.
Figure 2
Flush Mount
Figure 3
Surface Mount
