9
ancHoraGE FIttInG InstallatIon
(continue)
If the car is fitted with a child restraint anchorage point. Locate the
anchorage points behind the rear seating position (consult the car
owner’s handbook for the location of the anchorage point). Remove
the thread plug from the parcel shelf / floor/ roof and install the
attachment bolt as shown in Fig 1.
WarnInG
WarnInG
CAUTION: DO NOT OVERTIGHTEN
THE ATTACHMENT BOLT. MAXIMUM
TORQUE 20 Newton Metre.
Front of vehicle
If the car is not fitted with a child restraint anchorage point.
For sedans only – Drill a 9mm diameter hole in the parcel
shelf on the centre – line of the seating position as shown in Fig 2
(page 10). Install the anchor bolt as shown in Fig 3 (page 10).
For vehicles other than sedans – In Australia, consult your nearest
child restraint fitting station or traffic authority for vehicle inspection
to find the best, correct position for the placement of anchorage
point, and for the correct attachment bolt length and use of spacers.
In New Zealand, consult the agent for the vehicle.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND
METAL OR TO WOOD OR SYNTHETIC
STRUCTURES. WHEN DRILLING THE 9MM HOLE DO NOT
DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL
WIRING, OR RADIO SPEAKERS. WEBBING STRAPS MUST BE
PROTECTED FROM SHARP CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS DESCRIBED
ABOVE. IT MUST NOT BE HOOKED ONTO ANY OTHER OBJECT.
Lock Washer
A
nchor Fitting
S
pacers (if required)
V
ehicle Trim
Vehicle Metal Structure
Fig 1
Attachment Bolt
