XXXXX
24
23
sewn
end
4.
Attach 1st Harness Strap
Loops to Splitter Plate
As Shown
Sewn ends of the harness strap
loops
MUST
face towards you.
DO NOT
twist harness strap or
harness adjustment strap.
Make sure the same harness strap
loops are fitted
COMPLETELY ON
both sides of the splitter plate.
Correct
2.
Thread Harness Straps
into Shoulder Harness
Slots
If you will be using the lower
shoulder harness slots for smaller
infants, see pages 10-12.
WARNINGS:
Harness system must be installed
correctly. Failure to follow these steps can result in serious
injury or death.
3.
From Back, Thread
Harness Straps OVER
Metal Bar
DO NOT
twist harness straps.
If you have removed the harness straps from the
splitter plate, and the buckle tongues and chest
clip have been unthreaded from the harness
straps, follow the steps below to rethread them.
1.
Thread Buckle and
Chest
Clip
Harness strap ends go through
the
back
of buckle tongues and
through the chest clip
front to
back
as shown.
5.
Adjust Headrest to
Highest Position
6.
Undo Fasteners on Seat
Pad and Pull Headrest
Pad Off Bottom of
Headrest
Unthread harness straps from slots
on side of headrest.
Loosen harness straps.
Pull chest clip, harness straps, and
buckle tongues out from behind
the headrest and seat pad.
Slide harness straps into slots in
headrest pad.
Attach seat pad fasteners.
