DOREGRILL MAG 4 GAZ, Инструкция по эксплуатации

Страница: 27 / 43

INSTRUCTION MANUAL ROTISSERIE MAG GAZ
SEPTEMBER 2011
27
Turn off and unplug the rotisserie
Loosen bolts with a wrench. Remove bolts and washers
Slide and remove glass protection
Remove old light bulb
Put new one in. NEVER touch the new bulb with your fingers: always use a soft protection
Once the bulb has installed, put back all protection the glass protection.
10.2.2 Opening of the technical Unit
The technical unit is located on the left saide of the rotisserie, behind the control panel. It is the
access to repair several electrical and Gas parts
This operation must be done by a qualified technician.
.
Before opening the unit, unplung the rotisserie and shut off the gas valve behind the machine.
Unscrew the exterior panel. Once the operation is completed, just put it back as originally
mounted..
10.2.3 Change of the Spit rotation
.
To cook heavy load of poultry without stopping the mechanism, the motors of the even spits turn
to one direction and the motors of the uneven spits turn to the opposite direction
This operation must be done by a qualified technician.
Control the rotation after turning off gas valve and electricity and then open the unit
With a screwdriver, remove the two screws of the rotor. Remove the coil bloc, flip it and put it back
on the bloc of the rotor
Put back the caliper and two screws; verify the coil runs without friction and tight the scews
Plug the motor and check the rotation prior to closing the Technical Unit.
10.2.4 Change of the injectors
This operation must be performed by a qualified gas Technician
IMPORTANT:
.In case of change of gas and in order torespect all rules and regulation, you must order
the replacement KIT and change the old label with the new one