EN - DORA METAL Spółka z o.o.
Chilling equipment
5
While key lock allows the user to avoid any undesired and potentially hazardous tempering with, if the controller is
installed in a publicly accessible place. To disable key lock, in INFO menu, set LOC=YES parameter.
To activate the
keyboard again, set LOC parameter to NO.
Unlock keyboard
- press the
button until
LOC
message is displayed,
- then, while holding the
button, press the
button.
- to exit this menu, press the
button or wait 10 seconds.
MOUNTING PRODUCT
Place the granite plate with cooling module mounted on a support structure (framing, cabinet, etc.)
Control panel of the device is suitable to be mounted in a support structure or decorative structures.
Dimensions of mounting hole for control panel: 125x75. Make sure to install control panel cover on the
inside.
When encasing devices make sure that adequate ventilation of the unit is provided. In the encasing,
opposite the condenser, drill ventilation (through) holes to ensure free movement of cooling air for the
condenser. The area of holes ensuring free movement of cooling air should not be smaller than the area of
outline of the condenser. Make sure to position the unit at least 25cm from the wall.
PREPARATION FOR STARTUP. CLEANING AND MAINTENANCE
Commissioning and maintenance can be carried out by personnel in charge on condition the below
recommendations are strictly followed. The manufacturer will decline all responsibility for any operations
performed on the device without following recommendations herein.
Before any maintenance works, make sure the device is disconnected from power supply. Do
not remove any protection systems
.
Before commissioning remove protective foil. Clean external and internal surfaces using warm water
with degreaser for washing kitchenware, with a soft cloth, following the polished direction, rather than in
Mounting sequence:
1. Before foamed housing is mounted, bond discharge pipe in granite plate.
2. Spread thermal-conductivity compound evenly over the aluminium plate,
leaving 20mm space from edge of the plate.
3. Apply adhesive on free space of the aluminium plate.
4. Bond the housing to the granite plate and bolt using bolts M6 + serrated
washers.
Granite plate
Foamed housing
Tube
20x2 L=100
Detail A
Thermal-conductivity compound
Adhesive
Aluminium plate
Sikaflex-11FC
adhesive
Serrated washer
Bolt M6
Adhesive