Doppler Systems DDF7000, Руководство пользователя

Страница: 44 / 64

40
Doppler MPT Users Manual
The DDF7056 Yaw Rate Sensor is used to provide a faster update of the heading in mobile
applications where the vehicle is performing frequent turns. This device outputs an NMEA message;
however, its baud rate is 38.4 k. Therefore, the MPT User Interface software must be used to set
the baud rate to 38.4 k prior to using the yaw rate sensor.
USB RECEIVERS USB RECEIVERS USB RECEIVERS USB RECEIVERS
The DDF7001 currently supports the ICOM R1500, ICOM R2500, ICOM R8600, AOR SR2200, and
the AOR DV1 USB based receivers. The DDF7001 configures the receiver to receive narrow band
FM transmissions required for the direction finder to work properly. Currently only frequency,
squelch, and receiver volume setting is implemented; however scan commands are supported within
the Doppler SignalTrack and TargetTrack applications that make use of the receiver command pass
through feature.
To use the AOR DV1, the audio input to the DDF7001 must be reconfigured. The following steps
describe this conversion
1. Remove the 4 screws holding the base and remove the base
2. Remove the jumper shown in the figure below and set it aside
3.
Reinstall the base using the 4 screws.