Dopo D7015, Руководство пользователя

Страница: 19 / 24

DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission of the U.S.
Government.
The exposure standard for wireless mobile devices employs
a unit of measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is 1.6W/kg. Tests for
SAR are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well
below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only
the poser required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output.
The highest SAR value for the device as reported to the FCC
when tested for use when worn on the body, as described in
this user guide, is 1.23 W/kg. (Body-worn measurements differ
among device models, depending upon available accessories
and FCC requirements.)
While there may be differences between the SAR levels of
FCC NOTICE
The following statement applies to all products that have
received FCC approval. Applicable products bear the FCC
logo, and/or an FCC ID in the format FCC ID:xx-xxx-xxx
on the product label.
This mobile device complies with part 15 of the FCC Rules.
Operation is subjected to the following two conditions:
This mobile device may not cause harmful interference,
and this mobile device must accept any interference received,
including interference that may cause undesired operation.
This mobile device has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the party
RF EXPOSURE INFORMATION (FCC SAR)
Compliance Information
responsible for compliance could void the user's authority to
operate the equipment. The antenna(s) used for this
transmitter must not be colocated or operating in conjunction
with any other antenna or transmitter.
19 EN
D7015