Doosan P185WJD-D75, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 64

Operating & Maintenance Manual MAINTENANCE
46 Book: 46490694 (03-2010) Rev A
Scavenge Line
WARNING
!
High pressure air can cause severe injury or death from hot oil and flying
parts. Always relieve pressure before removing caps, plugs, covers or
other parts from pressurized air system.
The scavenge line originates at the manifold and terminates at the compressor airend near the
oil filter element. An orifice check valve is located on the scavenge tube.
Once a year or every 1000 hours of operation, whichever comes first, replace the separator
element and clean the scavenge orifice/check valve.
Note: Excessive oil carry-over may be caused by an oil-logged separator element. Do not
replace element without first performing the following maintenance procedure:
1. Check oil level. Maintain as indicated earlier in this section.
2. Thoroughly clean scavenge line, any orifice and check valve.
3. Assure minimum pressure valve/orifice is operational.
4. Run unit at rated operating pressure for 30 to 40 minutes to permit element to
clear itself.
Exterior Finish Care
This unit was painted and heat cured at the factory with a high quality, thermoset polyester
powder coating. The following care will ensure the longest possible life from this finish.
1. If necessary to remove dust, pollen, etc. from housing, wash with water and
soap or dish washing liquid detergent. Do not scrub with a rough cloth, pad, etc.
2. If grease removal is needed, a fast evaporating alcohol or chlorinated solvent
can be used. Note: This may cause some dulling of the paint finish.
3. If the paint has faded or chalked, the use of a commercial grade, non-abrasive
car wax may partially restore the color and gloss.