SAFETY
4
EN
Look for these signs on machines shipped to markets in North America, which point out potential hazards to the safety of you
and others. Read and understand thoroughly. Heed warnings and follow instructions. If you do not understand, Inform your
supervisor.
Red Background
Indicates the presence of a hazard which WILL cause serious
injury, death or property damage, if ignored.
Orange Background
Indicate the presence of a hazard which CAN cause serious
injury, death or property damage. if ignored.
Yellow Background
Indicates the presence of a hazard which WILL or can cause
injury or property damage. if ignored.
Blue Background
Indicates important set-up, operating or maintenance information.
DCT5JS Hammer Drills are designed for drilling concrete and other demolition work in construction applications.
Doosan Benelux SA is not responsible for customer modifications of tools for applications on which Doosan Benelux SA was not
consulted.
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING TOOL.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION IN THIS
MANUAL INTO THE HANDS OF THE OPERATOR.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
PLACING TOOL IN SERVICE
•
Always operate. inspect and maintain this tool in accordance
with all regulations (local, state, federal and country), that may
apply to hand held / hand operated pneumatic tools.
•
For safety, top performance, and maximum durability of parts,
operate this tool at 90 psig (6.2 bar / 620 kPa) maximum air
pressure at the inlet with 1/2" (13 mm) inside diameter air
supply hose.
•
Always turn off the air supply and disconnect the air supply
hose before installing, removing or adjusting any accessory on
this tool, or before performing any maintenance on this tool.
•
Do not use damaged. frayed or deteriorated air hoses and
fittings.
•
Be sure all hoses and fittings are the correct size and are
tightly secured.
•
Always use clean, dry lubricated air at 90 psig
(6.2 bar / 620 kPa) maximum air pressure. Dust, corrosive
fumes and/or excessive moisture can ruin the motor of an air
tool.
•
Do not lubricate tools with flammable or volatile liquids such as
kerosene, diesel or jet fuel.
•
Do not remove any labels. Replace any damaged labels.
USING THE TOOL
•
Always wear eye protection when operating or performing
maintenance on this tool.
•
Always wear hearing protection when operating this tool.
•
Keep hands, loose clothing and long hair away from rotating
end of tool.
•
Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
•
Keep body stance balanced and firm. Do not overreach when
operating this tool.
•
Tool accessories may continue to impact briefly after throttle is
released.
•
Air powered tools can vibrate in use. Vibration, repetitive
motions or uncomfortable positions may be harmful to your
hands and arms. Stop using any tool if discomfort, tingling
feeling or pain occurs. Seek medical advice before resuming
use.
•
Use accessories recommended by Doosan Benelux SA.
•
This tool is not designed for working in explosive atmospheres.
•
This tool is not insulated against electric shock.
The use of other than genuine Doosan Benelux SA replacement parts may result in safety hazards, decreased tool performance,
and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorised trained personnel. Consult your nearest Doosan Benelux SA Authorised Service
Centre.
DANGER
WARNING
CAUTION
NOTICE
NOTICE
DANGER
NOTICE