272mp
272wp
272i
+ - DA0 DA1 LD1 LD2
+ - DA0 DA1 LD1 LD2
+ - DA0 DA1 LD1 LD2
SOUNDER
Bi-color
LED
To
Control
Panel
To
Control
Panel
To
Control
Panel
+
DA0 DA1 LED
SW1
SW1
SW1
P1
red
black
r
b
r
b
r
b
red LED
green LED
yellow LED
black
red
If this product does not seem to operate properly, please call
our Technical Department toll free at 1-800-343- 9502 (781-821-5566)
Monday -Friday 8:00 am-7:00 pm EST.
We understand your time is valuble, and we know that calling
our Technical Support Department will ensure that you’ll make the most
profit possible with your IEI product. Thank you for your purchase. We
appreciate your business.
International Electronics,Inc.(IEI) warrants its products to be free
from defects in material and workmanship, when they have been installed in
accordance with the manufacturer’s instructions, and have not been modified
or tampered with. IEI does not assume any responsibility for damage or
injury to person or property due to improper care, storage handling, abuse,
misuse, normal wear and tear, or an act of God.
IEI’s sole responsibility is limited to the repair (at IEI’s option) the
replacement of the defective product or part when sent to IEI’s facility (freight
and insurance charges prepaid), after obtaining IEI’s Return Merchandise
Authorization. IEI will not be liable to the purchaser or any one else for inci-
dental or consequential damages arising from any defect in, or malfunction
of, it’s products.
This warranty shall expire two years after shipping date for
DOOR-GARD keypads. Except as stated above, IEI makes no warranties,
either express or implied, as to any matter whatsoever, including, without
limitation to, the condition of its products, their merchantability, or fitness for
any particular.
272MP- No backlighting if
Weigand panel power out-
puts 5v to Weigand read-
er. A separate (12vdc)
supply will be needed with
a common ground
between keypad and
Weigand panel.
P1- On = Backlit enabled
(12vdc only)
Off = Backlit disabled
BASIC WIEGAND CONTROL PANEL
+
DA0 DA1 LED
SW1
P2
P1
272xt
To
Control
Panel
red
black
black\white
white\yellow
If LED does not change states, a “ pull-up “
resistor may be required. Using a 10k
Ω
Ω
¼w
resistor, connect one end to V+ and the other end
to Led @ the control panel.
Current Draw
@ 5VDC - 13.2ma MAX
@12VDC- 38.2ma MAX
Current Draw
@ 5VDC - 4.6ma MAX
@12VDC- 11.4ma MAX
Current Draw
@ 5VDC - 9.9ma MAX
@12VDC- 16.9ma MAX
