DongFeng DFA1063DJ10-301, Руководство по обслуживанию

Страница: 41 / 142

Transmission
MT-17
flexible shaft clip on the bracket, then connect the flexible shaft with shift rock arm, the transmission should be
in neutral position.
When assembling, the flexible shaft core must not be twisted. When connecting the flexible shaft with gear-
box, the end section of flexible shaft should be about 100mm line, then it can be bent, the bending radius is not
less than 200mm.
When connecting the flexible shaft two end with
other parts, pay attention to assemble direction, it should
not be crooked.
Lubrication normally
Lubricating grease need not be used in flexible shaft
control system. If the noise is found in operating the flex-
ible shaft control system or it is difficult to operate the
control system, it is necessary to turn over the cab to
check whether the lubricating grease is sufficient in dirt
boot of shift level support ball knob and in dirt boot of
flexible shaft ball joint assembly. If necessary, add the
No.2 industrial Li base lubricating grease.
1.Shift flexible shaft clip
2.Selective shift flexible shaft 3.Selective flexible shaft bracket
4.Shift rock arm