DongFeng DFA1063DJ10-301, Руководство по обслуживанию

Страница: 32 / 142

Transmission
MT-8
Transmission Disassembly
Disassembly procedure
Before disassemble assembly, park the truck on the flat ground, shift the transmision in neutral position,
switch off the power and wedge up the front and rear wheel to ensure the safety.
1.Tilt the cab.
2.Screw off the drain plug screw, drain off the lubricant oil from transmission when the vehicle is warm.
3.Disassemble the propeller shaft assembly and intermediate support bearing.
4.Screw off four tightening bolts of transmission and clutch housing.
5.Remove speedometer flexible shaft, reverse speed switch, and separate the parking brake steel wire and rocker.
6.Disassemble transmission control system.
7.Remove the return spring and dowel pin of the clutch's slave cylinder then put the clutch's slave cylinder assem-
bly onto frame safety.
8.Remove wire and tube.
9.Disassemble transmission with transmission jack and steel wire.
Disassembly
1.Remove transmission upper cover assembly, gasket,
power-take-off hole cover, reverse gear inspect hole
cover and output shaft rear bearing cover.
2.Disassemble input shaft bearing cover and gasket from
front end of transmission, tap input shaft slightly from
right to left with copper bar, take out the input shaft
with bearing from front end.
Take out main shaft front bearing and input shaft
rear bearing.