Dong Feng ZB 65, Руководство оператора

Страница: 43 / 55

Factory Direct Tractors
Operating Instructions
4-2
7. Slowly release the clutch pedal and the tractor
will start to move.
Caution:
1.
Do not drive the tractor with the park brake on.
2. Do not drive with your foot resting on the clutch
pedal.
Safety precautions:
1.
Releasing the clutch pedal suddenly can make
the tractor lunge forward dangerously.
2. It is best to avoid shifting gear while you are
driving. Select the gear you want to work in,
then move off. To change gear, stop the tractor
by stepping firmly on the clutch pedal.
3.
Interlock the left and right brake pedals before
starting. Uneven braking can result in a sharp
turn, unbalancing the tractor, which could even
tip it over.
4. Do not allow any person other than the driver to
ride on the tractor.
5. Do not drive the tractor close to the edges of
ditches or banks which may break under its
weight, especially when the ground is loose or
wet.
6.
When turning the tractor, slow the engine speed
down and, if necessary, engage a lower gear.
7. Do not drive the tractor on the road with the
P.T.O. engaged and the implement in motion.
8.
After using the diff lock, make sure it has been
released.
9.
When going down a slope, use the slowed
engine to control the speed, (engine braking).
Relying only on the brake pedal is dangerous.
Never depress your clutch to free-wheel when
travelling down steep slopes.
4.3.2 Stopping
1. Slow the engine down.
2.
Step on both the clutch and brake pedal and the
tractor will stop moving.
3. Move the main gearshift and shift lever to the
neutral position and release the clutch pedal.
4.
Interlock the left and right brake pedals then
apply the park brake.
Safety precautions:
1.
When parking, be sure to apply the park bake.
2.
If you have no other option than to park on a
slope, take an added precaution against rolling
by placing stones or a wheel chock against the
rear wheels on the down hill side.
3.
Before getting off the tractor, make sure you
stop the engine and lower the implement to the
ground for safety.
4.4 Check during driving
While driving, check the instrument gauges to
make sure all systems are functioning normally.
4.4.1 Coolant
Prior to starting the engine, follow the pre-start
checks outlined in the service schedule 6.2.1 on
page 6-1. Also check and rectify the following:
1.
Low coolant level or coolant leaks.
2. Foreign matter on the radiator screen and dust
and dirt between the radiator fins.
3. Fan belt drive tension.
4.
Unnecessary addition of anti-freeze in climate
locations that don’t freeze.
Safety precautions:
To remove the radiator cap, wait for about 10
minutes after stopping the engine. Release the
cap slowly to release any remaining pressure
carefully. Immediate removal of the radiator cap on
a hot engine, allows scalding coolant to spray out
burning the operator.
4.4.2 Engine oil pressure indicator
The oil pressure gauge indicates whether the
engine is receiving adequate oil pressure. If the
indicator shows an incorrect operating pressure,
or the oil warning lights up immediately stop the
engine and check:
1. The engine oil level. (See page 6-1).
2. External engine oil leaks.
3. Electrical connection at the gauge & sender.