A3
Donaldson Company, Inc.
Collector Installation
This equipment is not designed to support site ducts, piping, or electrical services. All ducts, piping, or electrical
services must be adequately supported to prevent injury and/or property damage.
Site selection must account for wind, seismic zone, and other load conditions.
Equipment may reach peak sound pressure levels above 80 dB (A). Noise levels should be considered when selecting
collector location.
Collector Location and Site Selection
Equipment location must conform to all codes and standards, should be suitable for the type of dust being handled and should
ensure easy access for service and utility connections.
Delivery and Inspection
Upon arrival inspect collector and report any damage to delivery carrier. File any damage claims with the delivery carrier. Request
a written inspection report from the Claims Inspector to substantiate all damage claims.
Compare the collector received with the description of product ordered. Report any incomplete shipments to the delivery carrier
and your Donaldson Torit representative
Unloading and Positioning
(DFEP Collectors are generally packaged and shipped laying on their side)
Failure to lift the collector correctly can result in severe personal injury and/or property damage.
Label on pack slip and bill of lading will state weight of the collector as delivered.
1. Lift the packaged collector from transport container.
2. Remove any crates or shipping straps.
3. Inspect for any damage and/or missing parts and report to freight carrier.
4. Check for any hardware which may have become loose during shipment and tighten as necessary.
5. Locate the top lifting points (2) on the upward facing side of the collector.
6. Secure lifting straps to both lifting points.
7. Slowly lift the collector and allow the base of collector to pivot under the lifting points.
8. Once the collector has been lifted off the pallet, remove the pallet.
9.
.
10. Continue lowering the collector slowly while the top of the collector is allowed to pivot over the collector base until the collector
11. Remove lifting straps from both lifting points. Collector can now be lifted and moved into position using a fork truck.
12.
Torit
representative.
13. Pick up the collector with fork truck and place upright on the shipping pallet. T
can also be lifted and transported using the four (4) top lifting points and a spreader bar.
14. Secure collector to foundation or support structure with appropriate anchors.
