DOMUSA TEKNIK JAKA 20 HFD CONDENS, Инструкция по установке и эксплуатации

Страница: 26 / 32

Jaka HFD Condens
Jaka HFD Condens Jaka HFD Condens
Jaka HFD Condens
24
24 24
24
17 17 17 17 . TROUBLESHOOTING TROUBLESHOOTING TROUBLESHOOTING TROUBLESHOOTING
This section provides a list of the most common burner and boiler failures.
17.1 17.1 17.1 17.1 Burner error code Burner error code Burner error code Burner error code
We have already mentioned that the burner is equipped with a cut-out system, indicated by the
reset button light. It may cut out accidentally, and in this case the steady red light on this button
will come on. You may unblock it by pressing the button for approx. 1 second. When the burner is
blocked and the steady red light is on, visual failure diagnosis may be activated, in accordance with
the error code table. To enter visual failure diagnosis mode, hold down the reset button for at least
three seconds.
Error code table Error code table Error code table Error code table
Red flashing LED code Red flashing LED code Red flashing LED code Red flashing LED code "AL" on "AL" on "AL" on "AL" on
term. 10 term. 10 term. 10 term. 10
Possible cause Possible cause Possible cause Possible cause
Flashes 4 times On No flame established when ignition safety time ends.
- Fuel valves defective or dirty
- Flame detector defective or dirty
- Burner maladjustment, no fuel
- Ignition unit defective
Flashes 4 times On External light during burner ignition
Flashes 7 times On Excessive flame loss during functioning (limited number of
repetitions)
- Fuel valves defective or dirty
- Flame detector defective or dirty
- Burner maladjustment
Flashes 8 times On Supervision of fuel pre-heater time
Flashes 10 times On Cabling fault or internal failure, output contacts, other
failures
During the failure diagnosis time, the control outputs are disabled and the burner remains off.
To exit failure diagnosis and activate the burner again, reset the burner control. Hold down the
reset button for approx. 1 second (<3 s).
17.2
17.2 17.2
17.2 Boiler failures
Boiler failures Boiler failures
Boiler failures
FAILURE FAILURE FAILURE FAILURE CAUSE CAUSE CAUSE CAUSE SOLUT SOLUT SOLUT SOLUTION ION ION ION
RADIATOR DOES
NOT HEAT UP
- The pump is not turning Unblock the pump
- Air in hydraulic circuit
Drain the installation and the
boiler (the automatic air bleed
valve cap must always be
loose)
EXCESSIVE NOISE
- Burner badly adjusted Correctly adjust it
- Flue not correctly sealed Eliminate any leaks
- Flame unstable Examine the burner
- Flue not insulated Suitably insulate it
17.3 17.3 17.3 17.3 Thermostat Thermostat Thermostat Thermostat
Fumes temperature
safety thermostat (TH)
Boiler temperature
safety thermostat (TS)
If the boiler goes into safety lockout due to overheating of the boiler (TS) or fumes (TH), reset by
pressing the appropriate button on the thermostat. To access the buttons, unscrew the black cap.