INSTALLATION MANUAL
EN
SURFACE INSTALLATION
All of the
SMALLY
models can be surface mounted with the aid of specific
supports. The installation can be carried out with the light power supply
cable in both an axial or radial position with respect to the installation
surface. In the event of a specific requirement a power wire exit hole can
nevertheless be drilled in other positions as long as it does not compromise
the integrity of the wire and/or the connector installed on it.
- Secure the plastic bracket (E) to the installation surface with the included
screws (F); insert the light (G) into the plastic support, applying light
pressure until it is completely fitted as illustrated in figure 6.
- If necessary, bore a ø
≥
8mm exit hole for the power supply cable as
illustrated in figure 7.
CONNECTING THE DEVICE TO THE POWER SUPPLY _ static light
configuration
- Connect
SMALLY-CUBIT-QUADRUM
only to a safe power supply with
12Vdc stabilised voltage (sold separately) and with power at least 10%
higher than the total load. For the total load calculation check plate data
printed on the product label.
- If more than one device must be connected to the power supply ensure
that the total sum of the power absorbed by the devices (check the plate
data shown on the product label) does not exceed the maximum power
permitted by the Converter.
FLUSH INSTALLATION ON METAL SURFACES
The
SMALLY ML
devices can be flush mounted on 0.7 mm thick (min.)
metal surfaces and on a ø 57 mm hole as illustrated in figure 3.
- The light must be anchored to the metallic bracket by inserting first one
spring and then the other, applying slight pressure until completely fitted
as illustrated in figure 4.
CONNECTION OF THE SMALLY-CUBIT-QUADRUM Plus (Plug & Play)
POWER CABLE
The
SMALLY Plus
,
SMALLY XS Plus
,
CUBIT Plus
,
QUADRUM Plus
(Plug &
Play) models refer to the configurations of the devices that have a built-in
disconnectable power cable. The
SMALLY Plus
,
SMALLY XS Plus, CUBIT Plus
and
QUADRUM Plus
power lead can be disconnected and allows the device
to be easily disconnected and removed if necessary. Follow the installation
instructions for connection of the cable to the device.
- For connection of the power cable to the device, insert the cable
connector (B) into the slot (C) on the device, until the safety hook (D) is
press-fitted into place as illustrated in figure 5.
- To remove the device power cable, press the safety release (D) slightly
with your finger and extract the connector (B) from the slot (C) on the
device as illustrated in figure 5.
