Dometic WA3200, Руководство по эксплуатации

Страница: 5 / 80

2. There should be 20 mm clearance to the wall
3. Ventilation must be provided as shown in alternatives
A, B, C or D (fig 2-3)
Figure 3.
4. The ventilation duct must at least measure 105 mm x
the width of the refrigerator
5. Only the entire cooling unit must project into the duct
as shown
6. Air passing through the duct must not be preheated
by any source of heat
7. Ventilation grills, if used, must have an free openings
of at least 200 cm
2
each
During installation, please ensure the mains plug is
accessible at all times.
5. Using the appliance
To start the refrigerator connect the plug to the socket
outlet and switch on the socket. The cooling fins should
show signs of cooling after about 3 hours.
The refrigerator needs about 6 hours at normal ambient
temperature to reach 6 °C in the storage compartment.
5.1. Initial operation
The device must be plugged into a properly
earthed socket.
The miniCool starts automatically with a self-test.
The LED flashes several times and after a while
continuous light will follow if the door is open.
The miniCool achieves its operating temperature
after several hours.
5.2. Temperature regulation
(fig. 4.)
The usual setting required is in the region of the middle
of the thermostat knob (Fig. 4), but this can vary with
conditions of load and installation. If it is found
necessary to change the setting, the knob can be
turned to a higher symbol to give a lower temperature,
or a lower symbol to givea higher temperature. The
effect of any adjustment can be checked by means of a
thermometer when the refrigerator has reached the
new temperature after some hours.
5
3. Cleaning
Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these, the cabinet
interior and the door should be washed with a warm solution
of sodium bi-carbonate. Finally wipe over with a cloth rinsed
in warm water only, and dry with a clean cloth. Do not wash
any plastic parts in water that is more than hand warm, and
do not expose them to dry heat. The outside of the cabinet
should be wiped down regularly with a clean, damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE
CLEANING MATERIALS ON ANY PART OF THE CABINET.
4. Positioning the appliance
When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS
THEREFORE VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING
During the refrigeration process, the appliance gives off
heat from the condenser (under the upper part of the
rear cover) into the surrounding air. The more ventilated the
condenser is, the more effective the refrigeration will be.
The other condition for satisfactory operation is that the
appliance stands on a flat surface. This is best seen by
placing a glass of water on top of the appliance.
It is important that the appliance is not directly exposed to
radiated heat (sunlight, radiator, near an oven, etc.).
4.1. Installation instructions
The refrigerator is equipped with an electrically heated
absorption cooling unit which is virtually silent in operation.
The fridge is designed for free-standing installation, but can be
built-in if the following conditions are complied with to ensure
satisfactory operation and maximum cooling efficiency.
IMPORTANT
Please follow the installation details below carefully
Guarantee is valid for products installed as described only.
1. The refrigerator must be level both directions
Figure 2.
GB