SIDE OF
VEHICLE
FRONT
SUPPORT
SIDE RAFTER POLE
AWNING FABRIC
SIDE VIEW
FIG. 2
FIG. 3
Zippers sewn on side
and under valance
6. Be sure the flaps are folded
out
from the screen
room. Starting at the roof, align top snap fasteners
on each side flap to wall of camper. Locate posi
-
tions of snap fasteners and mark with pencil. Drill
1/8” holes and install snap fastener with protruding
section pointing toward the screen room. Repeat on
other side. See FIG. 5. (See also specific instruc
-
tions in Constellation Supplement to Campers
Owner’s Manual.)
7. Align skirt at the right hand flap of screen room and
frame of camper. Attach PE clips sewn on skirt onto
frame ledge on underside of camper. See FIG. 4.
Attach PE clips or
hook strips to frame
Align skirt with right hand flap
of screen room
FIG. 4
Attach skirt to screen room
with hook & loop
fasteners.
8. Secure bottom of panels by driving the hook stakes
into the ground through the appropriate grommet.
Wrap screen room flaps around roof jacks. (See
FIG. 5)
9. Attach skirt to Screen Room with hook and loop
fasteners sewn into room and skirt. See FIG. 4.
Tie straps attach
around support pole
Grommets (7)
sets per unit
FIG. 5
Snap fastener (3 or 4)
on each side flap.
Snap fasteners
to point towards
screen room.
Wrap flaps around
roof jacks
Note:
The inner and outer sides of all panels can be
checked by looking at the snap fasteners. The round
black plastic ring in the vertical edge hems is on the in-
side surface.
2. Set up awning for installation of Trim Line Screen
Room.
3. To facilitate accurate installation, vehicle should be
parked on reasonably flat ground.
Open awning and install front support and side rafter
pole as shown in FIG. 2
4. After awning is set up, remove screen room from
carton, check for correct size and position it with
awning as shown in FIG. 3.
5. Fasten front of screen room to Trim Line bag awning
by joining zippers. Start at awning front and fasten
side panels to bottom side of awning. When attach-
ing screen room to awning at bag, pull bag down
and away from awning, making sure screen room is
fastened completely.
