8
EN
Installation
Slide Topper
q
w
e
6
Mounting Bracket Locations
q
Mounting Bracket
Below Flange
e
Incorrect Mounting
Bracket Location
w
Mounting Bracket
Directly on Flange
3. Verify the mounting location is flat and has solid
structural backing where the fasteners will penetrate
the surface.
4. Verify the mounting brackets are positioned at the
correct height in relation to the Slide Topper arms
and extension.
5. Mark the hole locations for the mounting brackets
using the mounting brackets as templates.
3.6 Preparing the Hardware
Assembly
Use this section to prepare the hardware for the
installation of the Slide Topper.
q
w
e
r
7
Rear View of Hardware Assembly
q
Torsion Rod
e
Cotter R-Pin
w
LH Arm
r
Extension
1. Carefully lay the FRTA onto a clean, well padded “V”
trough (or other well protected surface) to prevent
fabric damage.
2. Place the LH (left hand) arm onto the torsion rod.
3. Align the clip holes.
4. Install the cotter R-pin through the LH arm and into
the torsion rod until it securely snaps into place.
5. Repeat steps 2 – 4 for the other end.
I
Make sure the LH and RH (right hand) arms align
correctly with each other.
4 Installation
WARNING: FIRE OR ELECTRICAL SHOCK
HAZARD. Failure to obey these warnings
could result in death or serious injury.
• Make sure there are no obstacles like wires or pipes in
the way of the drill locations.
• Disconnect the 120 VAC power supply from the RV
before drilling or cutting into the RV.
• Disconnect the positive (+) 12 VDC terminal from the
supply battery before drilling or cutting into the RV.
