Dometic SILENCIO HC Series, Инструкция по установке и эксплуатации

Страница: 21 / 72

EN
HC 302, HC502 Troubleshooting
21
Clean the condensate drain when necessary. If it is blocked, the condensate
collects on the bottom of the refrigerator.
➤
Clean the door seals regularly.
Freestanding version: Clean the grid of the condenser and the compressor on the
back of the refrigerator with a vacuum cleaner regularly.
9 Troubleshooting
Water in or under the refrigerator
Display signals
Fault Possible cause Remedy
Water is leaking into the
inside of the
refrigerator. The condensate drain duct is
clogged. Clean the drain.
Medicines are preventing the water
from flowing to the collector. Make sure that medicines
do not touch the rear
wall.
Water is leaking onto
the floor. There is too much water in the water
container. Clean the water
container.
Signal Explanation
General error
The display blinks each
second.
The display shows alternately the current inner temperature and
the active error code (fig.
2
1, page 3) (E1 or E2, see below).
Sensor failure
The display blinks and
shows “E1”.
The minimum and maximum values will be kept as the last known
values.
Low battery
The display blinks and
shows “E2” alternately
with the current tem-
perature.
The minimum and maximum inner temperatures are still visible
and will be updated from the current inner temperature reading.