6
ProPer boWl CleaninG
For stubborn bowl stains, use SeaLand
®
Toilet Bowl Cleaner
(Fig. A). It’s manufactured especially for use with all
SeaLand toilets. In certain locations where water is hard, a
build-up of lime may dull the toilet bowl finish. Restore the
shine with this SeaLand cleaner. If you cannot find it in your
area, contact Dometic for your nearest dealer. If the cleaner
is not available, you can also use most non-abrasive bath
-
room and toilet bowl cleaners (Bar Keeper's Friend
®
spray
cleaner, Clorox
®
toilet bowl cleaner, SaniFlush
®
toilet bowl
cleaner, etc.). Please follow label instructions.
To avoid damaging the Teflon
®
-coated seal,
Do noT uSe:
– abrasives (Comet
®
, Soft Scrub
®
cleansers etc.)
– caustic chemicals (Drano
®
clog remover, etc.)
– lubricants and cleaners containing alcohols or petroleum distillates
(Pam
®
cooking spray, Pine-Sol
®
cleaner, WD-40
®
lubricant, etc.).
Fig. a
® Bar Keepers Friend is a registered trademark of SerVaas Laboratories Inc.
® Clorox, Pine-Sol and Soft Scrub are registered trademarks of The Clorox Co.
® Comet is a registered trademark of Prestige Brands International.
® Drano is a registered trademark of S.C. Johnson & Son Inc.
® Pam is a registered trademark of ConAgra Foods.
® Sani-Flush is a registered trademark of Reckitt Benckiser Inc.
® Teflon is a registered trademark of DuPont Co.
® WD-40 is a registered trademark of WD-40 Company.
exTenDeD PerioDS oF non-uSe – ClearinG DiSCharGe lineS
Sanitation hoses should be cleared if toilet will not be needed for an extended period of time (more
than two weeks).
1. Fill toilet bowl with water and add 4 oz. (120 ml) of biodegradable laundry detergent (should
nOT
contain bleach).
2. Flush toilet, holding Flush switch down for about two minutes, and allowing toilet to cycle
through several flushes. Release Flush switch to close flush ball.
3. Turn off water supply to toilet.
4. Flush the toilet without water, allowing the vacuum pump to shut off after the flush. Repeat
three times. (This procedure will minimize any remaining water in the sanitation hoses.)
5. Turn off power to the vacuum pump.
6. Completely pump out holding tank.
If system will be subjected to freezing temperatures, please follow above procedure, then winterize
system as described on next page.
Turn oFF eleCTriCiTY anD WaTer To ToileT iF iDle For lonG PerioDS oF TiMe
If people will not be using the boat for a long time (vacation, maintenance, off-season, etc.), or in
the event of a long electrical power interruption, electrical power and water supply to the toilet and
vacuum generator should be shut off.
