- 27 -
diagnostic test
TO PERFORM A DIAGNOSTIC TEST, FOLLOW THESE STEPS:
Turn off the refrigerator by pressing the main power ON/OFF button.
1.
Press and hold the TEMP. SET button while pressing the ON/OFF button. Release buttons when display comes on.
2.
Press the TEMP. SET button to step through the 5 test options. The messages are displayed flashing - alternating be
-
3.
tween “
TEST INDICATION
” (e.g. F) and “
TEST RESULT INDICATION
” (e.g. E2).
no test function
test
indication
test result indication
1
All outputs off.
Display shows air temperature
in fresh food compartment
F
e.g. “41”
e2
Temperature sensor fault
“Unfiltered temperature in F”
2
Turn LAC heater on
LH
ON
LAC heater on
Press the lamp switch. The lamp should still be on.
3
Turn AC heater on
AC
ON
“ ”
AC heater on
AC heater is off. AC is not available.
4
D+ status (if D+ is connected)
Alternator voltage
DP
ON
“ ”
D+ high
D+ low
5
Run gas
LP
e1
ON
Fl
“ ”
Igniter and valve off. Gas hardware fault.
Igniter and valve on.
Igniter off and valve on. Flame detected
Igniter and valve off.
Gas problem. Check gas if flame is not ignited within 45 sec.
The diagnostic test should be performed by a service technician.