- 19 -
operating instructions
dispenser(s)
rm1350wid
If new installation or used for the first time after the RV has
been winterized/put into storage, the water tank, located inside
the refrigerator, must be filled with water. To fill the tank with
water, follow these steps:
Insert a glass and press the right lever for
1.
approx. 20 seconds.
Pull glass away.
2.
Repeat steps 1 and 2 until water begins dispensing.
3.
water dispenser
(rm1350wim & rm1350wid)
TO DISPENSE WATER, FOLLOW THESE STEPS:
Verify that the water valve supplying the refrigerator
1.
is turned on.
Insert a glass in the dispensing cavity and press the
2.
lever. This will activate a switch which turns
on an electric water valve at the back of the refrig-
erator. Water will flow through a separate tube and
out of the dispenser.
To stop dispensing, pull glass away from the lever
3.
before the glass is full.
If new installation, or used infrequently, dispense
numerous glasses of water before use. To keep the
water fresh, it is recommended to use the dispenser
every day.
ice dispenser
(rm1350wid)
In order to provide a smooth and
consistent flow rate of ice and to
avoid ice spillage, please make sure
to adjust the size of the ice cubes as
described in
ADjUSTING THE SIZE
OF CUBES
.
TO DISPENSE ICE, FOLLOW THESE STEPS:
Insert a glass in the dispensing cavity and press the
1.
left lever.
The ice maker has previously produced ice that are
2.
stored in a large bin. When the lever is pressed, a
switch is activated. It turns on a motor which rotates
the auger. When the auger rotates, it pushes ice out of
the bin, through a chute right into the glass.
To stop dispensing, pull glass away from dispensing
3.
arm before the glass is full. Allow ice chute to clear
before removing glass.
adjusting the size of cubes
If the ice maker was cleaned and drained, no ice cubes
will be dumped into the bin during the first cycle.
The first few cycles may have small cubes due to air trapped
in the water lines. The first container of ice cubes should be
dumped if the water system has been winterized or not used
for several weeks. Once the ice maker has run through several
cycles and if cubes are to small or sticking together, adjustment
is necessary on the amount of water entering the mold.
TO ADjUST THE SIZE OF CUBES, FOLLOW THESE STEPS:
Remove the protective cover from the ice maker
1.
mechanism. Using a flat-head screwdriver, place the
tip of the screwdriver in the slot. Twist the screw-
driver blade gently to loosen the cover.
Locate the adjusting screw under the protective
2.
cover. Turn the screw counterclockwise to increase
the size of cubes.
Turn the screw clockwise to decrease the cube size
3.
or if the mold is overfilling, and the cubes are stuck
together.
To prevent overfilling, do not turn the adjustment screw
more than one revolution at a time. Allow the ice maker
to cycle several times before another adjustment is
made. Be sure to replace the protective cover on the
cycle after the adjustments are complete.
Cover
Adjusting screw
rm1350wim
rm1350wid