7
off gas supply. While the button is pushed, this device
is temporary inoperative.
After finishing the gas operation the gas supply is to be
turned off at the gas bottle (Fig. 9.1.).
6. Mounting the wheels
(Fig. 6.)
The wheel set, found inside the appliance. Just slide
the wheels on to the axel and snap in the center hub
cap.
7. Useful suggestions
When planning a trip, run the appliance on 120 V
for 24 hours prior to departure. Place only pre-
cooled food in the appliance.
Frost forms on the evaporator panel when in
operation. When opening the cover or putting in
food, some of this frost melts and collects in the
form of water on the bottom of the appliance. Wipe
the water off occasionally using a sponge.
Avoid putting food with fragile packaging (such as
glass) into the unit, if you wish to pull it on its
wheels. Movements and shaking may cause such
items to break.
Walking downhill, make sure the refrigeration unit
does not roll onto your legs. In steep downhill
slopes, proceed behind the unit with the wheels in
front.
Once the unit is in its permanent position, make
sure that food does not come in contact with the
evaporator panel, as this can cause freezer burns
to the food.
8. Defrosting, cleaning and
maintenance
For defrosting, always unplug the appliance from an
electrical power source to avoid the risk of shock.
Make sure no other power source is connected (gas
or 12 V). Remove food from the unit and leave the lid
open. Depending on the temperature, frost melts in a
short time from the evaporator panel, with water
collecting at the bottom of the appliance. Wipe it off
using a towel. Afterwards, clean the appliance by
following the instructions in section 3. Leave the lid
ajar to prevent any odours from forming. The
appliance does not require any further maintenance.
Removal of the freset storage net for cleaning:
The plastic rivets can be reserved by pressing the
center shaft inward using a pen (figure 7). Once
this is done the plastic rivets can be removed.
Before reattaching the net, insert the center shafts
of the plastic rivets and then reposition the net and
rivets on the face of the refrigerator. Once the net
and rivets are positioned properly, push the center
shaft inward until you thear a click (figure 8).
Figure 6.
Figure 7.
Figure 8
.
All manuals and user guides at all-guides.com
