EN
Installing the awning
PW1500, PW1750
10
➤
Only for awnings with a width of 4 m to 5.5 m:
Drill one hole with a diameter of 6.5 mm through the left and the right side of the
awning. The hole has to be in a distance of 280 mm to the respective edge of the
awning and be on the same level as its counterpart in the long mounting plate
(fig.
c
, page 1).
➤
Only for awnings with a width of 4 m to 5.5 m:
Fasten the awning using a countersunk bolt, counter plate, serrated lock washer
and hexagon nut (fig.
d
, page 2).
➤
Insert the cover caps on the counter plates (fig.
e
, page 2).
➤
Drill two holes with a diameter of 3 mm through the awning and each of the long
mounting plates (fig.
f
, page 2).
➤
Drill one hole with a diameter of 3 mm through the awning and each of the short
mounting plates (fig.
f
, page 2).
➤
Fasten the awning with drill screws (fig.
f
, page 2).
➤
Retract the awning completely using the crank.
Installing awning on the piping rail
➤
Select the location of the installation.
In particular, check that there is enough space in the interior to mount the counter
plates at the points where the screws will be.
I
➤
Use two people to hook the awning on to the piping rail.
➤
Extend the awning about 50 cm using the crank.
➤
Mark where the holes are to be drilled (fig.
h
, page 2).
➤
Retract the awning completely using the crank.
➤
Use two people to lift the awning from the piping rail.
➤
At the marked points, drill holes with a diameter of 6.5 mm from the outside
through the external wall.
➤
Fill the drill holes in the vehicle wall with an acid-free silicone.
➤
Use two people to hook the awning on to the piping rail.
➤
Extend the awning about 50 cm using the crank.
NOTE
Measure the recommended mounting position for each counter plate
against the drill hole in the lower section of the awning.
