Dometic PERFECTWALL PW1100, Руководство по установке

Страница: 5 / 76

EN
PW1100 Installing the awning
5
5 Installing the awning
5.1 Notes on the installation position
See fig.
2
, page 1 to fig.
6
, page 1.
5.2 Installing the awning
During installation, observe the following general information:
• The mounting plates are bolted to the vehicle in the area of the rear hinge. In
addition, they are glued with installation adhesive (e.g. Sikaflex
®
-221 or a similar
product) to ensure the load is evenly spread and an optimal level of protection
from moisture is maintained.
• Observe the sealant manufacturer's instructions.
• Before installation, check the access to the screw joints. Make sure no cables or
cabinets are damaged when drilling.
• If you want to use an awning tent with the awning at a later date, ensure that the
vent windows and hatches remain accessible with erected tent when choosing
the awning size and installation position (fig.
5
, page 1).
• Carefully seal the drill holes to prevent moisture from entering the motorhome
wall.
• Do not open the awning or leave it unattended, before the awning has been fas-
tened to the mounting rails (fig.
8
, page 1 to fig.
i
, page 2).
• As part of the regular maintenance procedure, the screws on the rear hinge must
be tightened up by a service partner (fig.
7
, page 1). Ensure the users of the
vehicle are aware of this.
1. Select the location of the installation.
In particular, check that there is enough space in the interior to mount the coun-
ter plates at the points where the screws will be.
2. Mount the awning (fig.
8
, page 1 to fig.
i
, page 2).
5.3 Installing the crank bracket
➤
Mount the mounting bracket for the crank at a suitable location inside the vehicle
(fig.
j
, page 2 to fig.
m
, page 2).
DometicPW1100_INM_4445102590_EMEA18_xxxx-xx-xx.book Seite 5 Freitag, 19. Februar 2021 12:50 12