Dometic PerfectWall PW1000, Руководство по установке

Страница: 10 / 248

EN
Installing the awning PW1000, PW1500, PW1750
10
➤
Align the mounting plates on the vehicle and mark where the holes are to be
drilled (fig.
8
, page 1).
➤
At the marked points, drill holes with a diameter of 6.5 mm from the outside
through the external wall.
➤
Clean the outer sides of the mounting plates and the installation surface on the
vehicle.
➤
Fill the drill holes in the vehicle wall with an acid-free silicone.
➤
Insert the square-head bolts through the relevant holes in the mounting plates
(fig.
9
, page 1).
➤
To glue and seal, apply an elastic adhesive, such as Sikaflex
®
-221 for example, to
the back of the mounting plates (fig.
9
, page 1).
➤
Place all of the mounting plates through the drill holes and fasten them with
counter plate, serrated lock washers and hexagon head bolts (fig.
0
, page 1).
➤
Only for awnings with a width of 2.6 m to 3.5 m:
Fasten all of the mounting plates using a countersunk bolt, counter plate, ser-
rated lock washer and hexagon nut (fig.
a
, page 1).
➤
Only for awnings with a width of 4 m to 5.5 m:
Fasten the inner (narrow) mounting plates using a countersunk bolt, counter
plate, serrated lock washer and hexagon nut (fig.
a
, page 1).
➤
Wait until the glue has set. For further details, please refer to the information
provided by the sealant manufacturer.
➤
Use two people to hook the awning on to the mounting plates (fig.
b
, page 1).
➤
Extend the awning about 50 cm using the crank.
➤
Only for awnings with a width of 4 m to 5.5 m:
Drill one hole with a diameter of 6.5 mm through the left and the right side of the
awning. The hole has to be in a distance of 280 mm to the respective edge of the
awning and be on the same level as its counterpart in the long mounting plate
(fig.
c
, page 1).
➤
Only for awnings with a width of 4 m to 5.5 m:
Fasten the awning using a countersunk bolt, counter plate, serrated lock washer
and hexagon nut (fig.
d
, page 2).
➤
Insert the cover caps on the counter plates (fig.
e
, page 2).
➤
Drill two holes with a diameter of 3 mm through the awning and each of the long
mounting plates (fig.
f
, page 2).
DometicPW1000-PW1500-PW1750_INM_4445101838_EMEA18_202x-xx-xx.book Seite 10 Freitag, 5. März 2021 8:30 20