Dometic PERFECTVIEW CAM80AHD, Инструкция по установке и эксплуатации

Страница: 16 / 196

Mounting the camera CAM80AHD
EN
16
➤
Using a hammer and centre punch, gently pre-punch the previously marked points to prevent
the drill head from slipping off.
If you want to screw on the camera with self-tapping screws (fig.
b
, page 6)
A
➤
Drill Ø 4 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the camera bracket on with the 5 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through the
construction (fig.
c
, page 6)
A
➤
Drill Ø 4.5 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the camera bracket on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer threaded screws.
Creating a through-hole for the camera connection cable (fig.
d
, page 6)
I
A
➤
Drill a hole of Ø 16 mm near the camera.
➤
Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
➤
Place cable sleeves in all sharp edged ducts.
Mounting the camera
A
NOTICE! Risk of damage!
The holder may only be attached to steel panels with a minimum thickness of 1.5 mm
using self-tapping screws.
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell when they are tightened.
Use larger washers or metal plates if necessary.
NOTE
If possible, use available openings – such as ventilation grilles – to feed the connection
cables through. If there are no existing openings, you must drill a hole with a
16 mm diameter.
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill head to come out
NOTICE! Risk of damage!
Only use the screws supplied to mount the camera in the camera bracket. Longer
screws will damage the camera.
CAM80CM-AHD-IO-16s.book Seite 16 Freitag, 21. Dezember 2018 11:55 11