5
INSTALLING REFRIGERATOR IN
ENCLOSURE
Securing the Refrigerator
After the refrigerator is put in place, the refrigerator is to
be secured in the enclosure with six screws (not in-
cluded). The screws have to be installed in the following
order:
STEP 1: Two screws installed through the front base,
which includes the lower front strip installation.
The refrigerator is provided with a lower front strip
(shipped as a loose part). The front strip is to be attached
after the refrigerator is set into the cutout opening.
1. Install the lower front strip by sliding it under the
bottom hinge plates, as shown in FIG. 5.
2. Secure the refrigerator and the lower front strip with
two screws: One screw through each hinge. See
FIG 6.
FIG. 4
The transport support at the rear of the refrigerator can
be removed if necessary for the installation of the refrig-
erator in the enclosure. (See figure above).
NOTE:
DO NOT install the appliance directly on
carpeting. Carpeting must be removed or
protected by a metal or wood panel beneath
the appliance, which extends at least full
width and depth of the appliance.
Caution: Use care when installing the refrigerator. This
refrigerator is equipped with the latest vacuum insulated
panel technology. These insulating panels are located
on the Top, Back, Bottom, Sides and Doors of the refrig-
erator.
If the surface is punctured, loss of insulation will occur,
resulting in poor refrigerator performance.
NOTE: A wood strip must be in place across the upper
opening of the enclosure. The top frame of the refrigera-
tor will be anchored to the wood strip with screws, see
FIG. 10.
The refrigerator must be installed in a substantial enclo-
sure and must be level. When installing the refrigerator
in the enclosure, all areas within the recess in which the
refrigerator is installed must be sealed.
Make sure that there is a complete seal between the
front frame of the refrigerator and the top, sides and
bottom of the enclosure. A length of sealing strip is ap-
plied to the rear surface of the front frame for this pur-
pose, see FIG. 4. The sealing should provide a complete
isolation of the appliance’s combustion system from the
vehicle interior.
NOTE: Be careful not to damage the sealing strip when
the refrigerator is put in place.
FIG. 5
FIG. 6
