Dometic MAGICCOMFORT MSH300, Инструкция по установке и эксплуатации

Страница: 16 / 192

EN
Installing the seat heater MSH300, MSH 301
16
Preparing the heating elements
A
I
➤
Place the heating elements on the seat and backrest.
➤
If there are anchoring grooves in the seat or the backrest, mark these areas on the
heating elements.
➤
Mark the required lengths. Take into account the depth of the anchoring
grooves, if present. The heating element is inserted in these anchoring grooves.
➤
Trim the heating element to the required length.
➤
Customise the cut-out sections as required.
➤
Insulate all the trimmed ends with the insulating material.
NOTICE!
Insulate all the trimmed ends with the insulating material supplied to
prevent a short circuit.
NOTE
•
You can cut the heating elements to the required length and shorten
the lengths of the two conductor paths.
•
You can cut out a section of the heating element in the area of the
anchoring grooves on the seat or the backrest. Make sure the cut-out
sections are only made between the two black seams (fig.
5
,
page 4).
•
Do not cut the mat lengthways, otherwise it will not be heated in the
area of the incision (fig.
5
, page 4).
•
The heating surface on the backrest only needs to extend approx.
30 – 35 cm above the seat, as the driver only leans against this area
when sitting normally (fig.
6
, page 4).
MSH300--IO-16s.book Seite 16 Donnerstag, 13. Juli 2017 10:28 10