Dometic GP-MPPT-60/10, Инструкция по установке и эксплуатации

Страница: 9 / 156

GP-MPPT-60/10 Using the device
EN
9
1. Connect the battery connector to the controller (fig.
1
, page 3, 6 ).
2. Connect the positive solar panel connector to the controller (fig.
1
, page 3, 4 ).
3. Connect the negative solar panel connector to the controller (fig.
1
, page 3, 5 ).
4. Insert the fuse (fig.
1
, page 3, 8 ) and turn on the circuit breakers.
When the controller is connected to the battery bank, it will start a power-up sequence which takes several seconds
to complete.The readiness of the controller is indicated by a LED signal (see chapter “LED indications” on page 9).
I
8 Using the device
8.1 Device elements
8.2 LED indications
NOTE
When the solar panel is exposed to light, it supplies a DC voltage to the solar charge
controller.
fig.
1
,
page 3
Description
1 Solar charge controller
2 Temperature sensor
3 Charging status LED
4 Battery status LED
5 Positive solar panel connector (red wire)
6 Negative solar panel connector (black wire)
7 Battery connector
8 RS485 connector
9 Fuse
10 Battery
11 Solar panel
LED Status Indication
On Not charging. Solar panel connection normal but low volt-
age input from solar module.
Off No solar panel voltage (night time), or solar panel connec-
tion problem.
Flashing slowly Charging.
Flashing fast Solar panel overvoltage.
GoPowerDometicGP-MPPT-60-10_IOM_4445103825_EMEA16_2022-xx-xx.book Page 9 Friday, October 14, 2022 5:04 PM