
GP-MPPT-60/10
Installing the device
EN
7
•
Anodized aluminum extrusion with built-in heat dissipation
•
Fully encapsulated design prevents damage from water, corrosion, insects and/or dust
•
Works with 12 or 24V battery systems (automatic battery voltage detection)
•
Compatible with 60-cell modules
•
Converts excess array voltage into additional charging current
•
Allows up to 50% oversized array power for adding additional capacity in low-insolation months
7 Installing the device
7.1 Mounting the device
A
A
I
I
1. Drill 4 holes.
2. Mount the solar charger with appropriate fasteners.
7.2 Choosing proper wires and fuses
A
A
NOTICE! Damage hazard
The controller warms up during operation. Make sure it is installed on a non-flammable
surface.
NOTICE! Damage hazard
Allow at least 15 cm of space above and below the controller for proper cooling.
NOTE
The controller must be mounted as close to the battery as possible.
NOTE
The controller is designed to be mounted vertically.
NOTICE! Damage hazard
For proper operation of the charging system, choose the size of wires between the
solar panel and the battery carefully.
NOTICE! Damage hazard
Do not exceed wire length of 7.6 m from solar panel to the battery.
GoPowerDometicGP-MPPT-60-10_IOM_4445103825_EMEA16_2022-xx-xx.book Page 7 Friday, October 14, 2022 5:04 PM
Содержание GP-MPPT-60/10
Страница 153: ...GoPowerDometicGP MPPT 60 10_IOM_4445103825_EMEA16_2022 xx xx book Page 153 Friday October 14 2022 5 04 PM ...
Страница 154: ...GoPowerDometicGP MPPT 60 10_IOM_4445103825_EMEA16_2022 xx xx book Page 154 Friday October 14 2022 5 04 PM ...
Страница 155: ...GoPowerDometicGP MPPT 60 10_IOM_4445103825_EMEA16_2022 xx xx book Page 155 Friday October 14 2022 5 04 PM ...