16
- Insert control switch while holding socket in place with your finger.
(Figure
53)
- Screw in bulb while constantly holding down the socket.
(Figure 54)
The bulb holds the socket elements in place, then the reflector mount can
be popped open. When snapping shut, the blocking tab should be slightly
pressed with a screwdriver.
(Figure 55)
- After snapping shut, fitting should be tested.
- Replacing light shield. Make sure that the groove fits correctly on the light
shield.
While pushing aside the blocking tab of the reflector plate with a
screwdriver, the casing can be pushed in place.
(Figure 56)
- Prior to installing the lighting device, the securing screws must be
reinserted into the lighting device so that the tips of the screws overhang
by 1-2 mm. These help positioning.
Figure 52
Figure 51
Figure 53
Figure 54
Figure 55
