Dometic DOTRM13B, Руководство по установке

Страница: 13 / 18

DRILL THE HOLES IN THE WALL AND UPPER CABINET.
BE VERY CAREFUL WHEN DRILLING HOLES INTO THE WALL.
Electrical wires could be concealed behind the wall covering
and if the drill hits them you could get an electric shock.
1. Find the points on the wall template labeled D, E, F, and G. Drill a 3/16" diameter hole at any points that
are over a wall stud. Drill a 3/4" diameter hole at any points over drywall.
2. Locate the wall stud closest to the center of the areas marked H and I on the wall template. Drill 3/16" holes
into the wall stud in each of the areas. If a wall stud is not located within these areas, drill 3/4" diameter
holes nearest to the center of the areas as possible.
If there is not a wall stud within the areas marked H and I, or behind points marked D, E, F, and G,
DO NOT install microwave oven. (Consult building inspector.) There must be at least one stud in
those areas.
3. Cut or drill a 2" diameter hole at the area marked M.
Power supply cord hole on the upper cabinet template. If the upper cabinet is metal, you will need to cover
the edge of the hole with the power supply cord bushing (supplied) to prevent damage to the cord from the
rough metal edge.
YOU MUST COVER THE EDGE OF THE POWER SUPPLY CORD HOLE IN A
METAL CABINET WITH THE POWER SUPPLY CORD BUSHING. FAILURE TO
DO SO COULD RESULT IN DAMAGE TO THE CORD AND ELECTRIC SHOCK.
4. Cut out the venting areas (with the saber saw):
• Roof-Vented: cut out the shaded area marked L on the upper cabinet template.
• Wall-Vented: cut out the shaded area marked O on the wall template.
• Room-Vented: go to STEP 5, INSTALLING THE MOUNTING PLATE, located on page 14.
5. Complete whichever venting system you have chosen.
Use caulking compound to seal the exterior wall or roof opening around the wall cap or roof cap.
STEP 4: PREPARE THE WALL AND
UPPER CABINET FOR INSTALLATION
W A R N I N G
W A R N I N G
– 13 –