Dometic CT 4110, Руководство по установке

Страница: 25 / 248

EN
CT(E), CTLP, CT(E)S, CTW Installing the cassette toilet
25
6.3 Setting up the cassette toilet
A
I
1. Install the cassette toilet according to the description for the respective model
version.
2. Set up the cassette toilet so that it is flush to a vertical wall only.
3. Leave enough space so that actuation of the draining slider is not restricted.
4. For the installation, use the dimensional drawings:
– CT4050, CT(E)4110 : fig.
5
, page 5
– CTLP4050, CTLP4110 : fig.
6
, page 6
– CTS 4050, CT(E)S4110 : fig.
7
, page 7
– CTW 4050, CTW4110 : fig.
8
, page 8
6.4 Installing CT(E)4xxx models
The detached model CT(E)4xxx has no integrated water tank and no console. Set up
this model so that the wall behind it can accommodate the control unit of the toilet,
the electrical connections and possibly a water tank. It is best if you put a box in front
of the room wall (fig.
9
, page 9).
Note here that the cassette protrudes 110 mm out of the cassette housing (fig.
0
a ,
page 9). The base height is between 50 and 110 mm, depending on model
(fig.
0
b , page 9).
1. If a service door is installed: Align the cassette toilet according to the service
door.
2. Place the housing base flush with the installation box so that there is a clean
transition and no gap.
NOTICE!
All components of the system must be installed in frost-free areas. In
freezing temperatures, there is a risk of damage caused by frost.
NOTE
• When installing the cassette toilet in a wet room, the manufacturer
recommends that you connect the cassette toilet to the shower tray.
• The cassette toilet base is equipped with a protruding collar for
receiving the upper edge of the shower tray (fig.
4
, page 4).