EN
CFF12, CFF20, CFF35, CFF45, CFF70DZ
Troubleshooting
29
8.1
Lid past built-in stop (CFF35, CFF45 only)
If the lid has been forced past the built-in stop, proceed as follows (fig.
➤
Support the lid with one hand (
A
).
➤
Hold the latch down with the other hand (
B
).
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The DC outlet is dirty.
This results in a poor
electrical contact.
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
The fuse of the DC plug
has blown.
Replace the fuse in the DC plug, see
chapter “Replacing the DC plug fuse” on
page 27.
The device DC fuse has
blown.
Replace the defective fuse, see chapter
“Replacing the device DC fuse” on
page 26.
The vehicle fuse has
blown.
Replace the vehicle’s DC outlet fuse.
Please refer to your vehicle’s operating
manual.
The display shows an
error message (e.g.
“Err1”) and the appli-
ance does not cool.
The appliance has
switched off due to an
internal fault.
This can only be repaired by an
authorized repair center.
Problem
Possible cause
Remedy
A
B
e
DometicCFF12-20-35-45-70DZ_OPM_4445103133_APAC(en)_202x-xx-xx.book Seite 29 Dienstag, 21. Dezember 2021 8:54 08
Содержание CFF20
Страница 33: ...DometicCFF12 20 35 45 70DZ_OPM_4445103133_APAC en _202x xx xx book Seite 33 Dienstag 21 Dezember 2021 8 54 08...
Страница 34: ...DometicCFF12 20 35 45 70DZ_OPM_4445103133_APAC en _202x xx xx book Seite 34 Dienstag 21 Dezember 2021 8 54 08...
Страница 35: ...DometicCFF12 20 35 45 70DZ_OPM_4445103133_APAC en _202x xx xx book Seite 35 Dienstag 21 Dezember 2021 8 54 08...
