Dometic AH-Passport I/O Compact, Инструкция по установке и эксплуатации

Страница: 8 / 32

8
EN
Installation Passport I/O Digital Controls
JP1
Display Jacks
Inside Temperature Sensor Jack
Required Water-In Temperature Sensor
Optional Water-Out Temperature Sensor
Optional Outside Air Temperature Sensor
JP2
Ground
Fan
Water Valve
Electric Heat Strip
Fan Run
Capacitor
L2
L2
L2
AC
L2
L1
L1
L1
L1
Optional DC
Blower
GND
For Humidistat
For Changeover Switch
COM COM
0-10 VDC
SMX DISPLAYS ONLY
4 CW Wiring Diagram
6 Installation
WARNING: ELECTRIC SHOCK HAZARD .
Turn power off before performing any electrical
installation or maintenance activities. Failure to
obey this warning could result in death or serious
injury.
NOTICE: Failure to obey the following notices could
result in damage to the product:
• Do not locate the display panel in direct sunlight,
near any heat-producing appliances, or in a bulkhead
where temperatures radiating from behind the panel
may affect performance.
• Do not mount the display in the supply-air stream or
above or below a supply-air or return-air grille.
• Do not mount the display behind a door, in a corner,
under a stairwell, or any place where there is no freely
circulating air.
• Do not staple sensor cables during installation.
• Do not use a screw gun and do not overtighten the
screws when mounting the display. Either method
may damage the display.
I The system’s built-in inside air temperature sensor
is located in the Passport control’s display panel.
An alternate air temperature sensor is required if
installing the display panel in a cabinet, enclosed
space, or any area where the accurate sensing of
the room temperature would be impaired.
This section describes how to install a Passport control.