7
EN
Oasis Elite 975 Series
Pre-Installation
To ensure the correct function and appearance, the
awning rail should be installed on a flat, straight surface.
In addition, the location should:
• Be a solid structure that will support the awning rail
and the back rail at all mounting points.
• Be parallel to the RV floor.
• Be centered over the door.
• Not interfere with the entry door swing when
the awning is completely extended. See “Door
Clearance” on page 5.
• Provide a minimum space of 0.5 in. (1.3 cm) at the top
and sides of the awning case. Additional clearance is
recommended to allow easier access for servicing.
5.3 Preparing the Awning Rail
q
w
6
Preparing the Awning Rail
q
LED Awning
(Top Only)
w
Typical Awning
(Top and Bottom)
1. Select the desired awning rail end on the RV into
which you will insert the awning fabric.
2. Use a flat-bladed screwdriver to flare (widen) that end
of rail, and file any sharp edges.
6 Awning Installation
WARNING: IMPACT OR CRUSH HAZARD.
This product should be installed in a controlled
environment (inside). Do
not
install the product
during windy conditions or when wind is expected.
The product could move unpredictably or become
unstable, causing it to detach, bend, or collapse.
Failure to obey this warning could result in death or
serious injury.
WARNING: FIRE OR ELECTRICAL SHOCK
HAZARD.
Before drilling or cutting into the RV, make sure
there are no obstacles (such as wires, pipes, etc.)
inside the RV’s roof, floor, or walls. Shut off the gas
supply, disconnect the 120 VAC power from the
RV, and disconnect the positive (+) 12 VDC terminal
from the supply battery. Failure to obey this warning
could result in death or serious injury.
CAUTION: LIFTING HAZARD.
Use proper lifting technique and control when
lifting the product. Failure to obey this caution
could result in minor to moderate injury.
NOTICE:
Failure to obey the following notices may
cause damage to the product:
• Always seal the wiring against weather and moisture
where the wiring and fasteners enter the RV’s walls,
roof, or floor. Always use sealant on clean parts and
surfaces . Otherwise, water leakage could occur.
• Do
not
pinch the wiring or allow it to rub against
sharp edges. If wiring is damaged, it
must
be
replaced by a qualified service technician.
