11
EN
Oasis Elite 975 Series
Post Installation
where connections to the awning hardware will be
made.
3. Make the appropriate wiring connections inside the
RV per the instructions supplied with the LED light
switch.
Wiring connections to the awning through the outside
RV wall will be made later.
7.4 Installing the LED Light
Connections
I
If the awning does not have an LED light strip, skip
this section and proceed to “Post Installation” on
page 11.
1. With the awning open, drill one 5/8 in. (1.6 cm)
diameter hole through the outside RV wall that is:
– Near the right end of the awning.
– Under the awning rail.
– Where the LED wiring can pass through wall
without interference.
2. Pull the wiring through the wiring hole and the
grommet.
3. Connect the LED switch wiring to the factory pre-
wired LED light strip per the instructions supplied
with your LED switch kit (installer supplied).
4. Secure the wiring to prevent pinching or other
damage during awning operation. Allow enough
slack in the wiring to safely accommodate possible
fabric movement.
8 Post Installation
This section describes the tasks you need to do after
completing the installation.
8.1 Testing the Operation
With power applied to the awning, open and close the
awning to verify that all parts are functioning correctly.
See “Awning Operation” on page 12.
8.2 Adjusting the Retraction and
Extension
The awning comes equipped with limit switches to stop
the motor at full extension and full retraction. These
limits are set at the factory and typically should not need
any adjustment by the installer or the user. If the limit
switches need to be adjusted, use a 3 mm hex key.
w
q
12
Limit Switches (Bottom, Left End)
q
Extension
Adjustment Screw
w
Retraction
Adjustment Screw
Retraction adjustments:
• If the front rail does not fit snugly against the case
when the awning is fully closed, turn the retraction
adjustment screw clockwise to adjust for more
retraction.
• If the motor does not turn itself off and continues
trying to turn when the awning is fully closed, turn
the retraction adjustment screw counterclockwise to
adjust for less retraction.
I
If the motor continues to try to turn when the
awning is fully retracted, damage to the motor or
the awning components may occur.
Extension adjustments:
• If the awning tries to overextend, turn the extension
adjustment screw counterclockwise to adjust for less
extension.
• If the awning does not fully extend, turn the extension
adjustment screw clockwise to adjust for more
extension.
