Dometic 3317114, Руководство по установке

Страница: 6 / 8

6
EN
Pairing the Wind Sensor Wireless Receiver
Step Operation
Audible
Alert
Awning
Movement
7
Press Down button
one time
None None
8
Press the Left P2
button one time
Beep x1
Awning jogs
9 Proceed immediately to “Verifying the Remote
Control” on page 6.
6 .3 Verifying the Remote Control
After pairing the remote control and the receiver, verify
remote control functionality by doing the following:
1. Press the Down button. The awning should extend.
2. Press the Up button. The awning should retract.
– If either button does not perform as expected,
see “Pairing the Remote Control” on page 5
and restart the pairing process.
3. Upon successful verification, proceed to “Pairing the
Wind Sensor” on page 6 (if applicable).
7 Pairing the Wind Sensor
NOTICE: Do not rely on the wind sensor to prevent
damage to the awning. The awning should always be
closed when unattended or when strong rain, wind, etc.
is expected.
The wind sensor is a key component to protect your
awning from the wind. This section describes how to
pair the wind sensor to the receiver and program the
sensitivity level. The information below applies to all
compatible power awning pro models.
I Complete each pairing step within four seconds
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
Step Operation
Audible
Alert
Awning
Movement
1
Remove the front
cover of the Wind
Sensor
None None
2
Set Sensor Dial
to 0
None None
3
Press Remote Left
P2 button one time
Beep x1
Awning jogs
4
Press Remote Left
P2 button one time
None None
5
Press Sensor
Programming
button one time
Sensor
Beep x1
Receiver
Beep x5
Awning jogs
6
Set Sensor Dial
to 5
None None
7
Press Sensor
Programming
button one time
Sensor Beep
x1
Awning
retracts
8
Set
Sensor Dial
to
desired level
None None