2
IMPORTANT SAFETY INSTRUCTIONS AND DOCUMENT SYMBOLS
This manual has safety information and instructions to help you eliminate or reduce the risk of accidents and injuries .
A. Recognize Safety Information
This is the safety alert symbol . It is used to alert you to potential physical injury hazards . Obey all safety messages that follow
this symbol to avoid possible injury or death .
B. Understand Signal Words
A signal word will identify safety messages and property damage messages, and will indicate the degree or level of hazard seriousness .
indicates a hazardous situation that, if
NOT
avoided, could result in death or serious injury .
indicates a hazardous situation that, if
NOT
avoided, could result in minor or moderate injury .
is used to address practices
NOT
related to physical injury .
Indicates additional information that is not related to physical injury .
C. Supplemental Directives
Read and follow all safety information and instructions to avoid possible injury or death .
Read and understand these instructions before [installation / use / service / maintenance] of this product .
Incorrect [installation / operation / service / maintenance] of this product can lead to serious injury .
The installation
MUST
comply with all applicable local or national codes, including the latest edition of the following standards:
U.S.A.
• ANSI/NFPA70, National Electrical Code (NEC)
• ANSI/NFPA 1192, Recreational Vehicles Code
CANADA
• CSA C22 .1, Parts l & ll, Canadian Electrical Code
• CSA Z240 RV Series, Recreational Vehicles
D. General Safety Messages
Failure to obey the following warnings could result in death or serious injury:
• This product
MUST
be [installed / serviced] by a qualified service technician.
•
PROJECTILE HAZARD. The unit can become a projectile if left attached during transit. Do
NOT
modify this product to allow
permanent installation . Failure to obey this warning could result in death or serious injury .
• FIRE OR EXPLOSION HAZARD . Use only an approved Dometic charger . Failure to obey this warning could result in battery
damage, death or serious injury .
• FIRE OR EXPLOSION HAZARD . Do
NOT
disassemble, crush, puncture or incinerate product . Failure to obey this warning
could result in death or serious injury. If the battery is disassembled, crushed or punctured, it could cause a fire or explode.
If it is incinerated, it could explode.
•
Always disconnect the Power Wand and remove it from the awning after use. Be sure to install the mud plug on the connec
-
tor to prevent debris from collecting . Otherwise, damage to product and/or RV could occur .
• This product is
NOT
intended for use on awnings with wind sensors, controllers, or devices that require constant power .
Otherwise, damage to product and/or RV could occur .
GENERAL INFORMATION
INCLUDED HARDWARE
(1) Connection Enclosure
(1) Connection Harness
(1) Mud Plug
BASIC COMPONENTS
Power Wand
Battery
Charger
REQUIRED TOOLS
Wire Strippers
Crimp Tool
3/8" Socket/Bit
Electric Drill
