Page 8
Siren Advanced User Manual
Factory Reset & Misc. Functions
Resetting the Siren
If needed, the Siren can be reset locally by following these steps. Only do this
when your Z-Wave controller is disconnected or otherwise unreachable. Beware
that resetting your device will disconnect it from the system:
1. Remove the BACK COVER and confirm that your Siren is powered up.
2. Press and hold the CONNECT BUTTON for at least 10 seconds then release.
A flashing light indicates a successful factory reset.
3. The Siren’s memory will be erased to factory settings.
Waking Up The Siren
Because the Siren is a battery powered device, it wakes up on regular intervals
to give battery and other status updates to the controller, as well as to accept
configuration settings from the controller. This helps to extend the battery life.
The device can be forced to wake up to submit these reports or accept new set-
tings immediately by simply pressing and holding the CONNECT BUTTON for two
seconds. The LED RING will flash once indicating successful wake up.
Factory Reset & Misc. Functions
