Domburg ASB4, Руководство пользователя

Страница: 12 / 14

ASB4 manual │ version 1 - 2022
Page:
11 from 14
When you have made your choice of servo, press the enter button for 1.5 seconds. The red and orange
LEDs will dim for a moment, and then light up again. This time you will also see LED X4 light up next to
the chosen servo. This is the first step in setting the servo. Each step is confirmed again by pressing the
enter button for 1.5 seconds, and this will be confirmed again by the LEDs going out briefly. Then the
next step will be shown and the servo will move to the already set position.
The steps are as follows:
X4: Position of
position A X3:
Position in the
middle
X2:
Position of
position B
X1: Speed of movement
Changing the positions is done with the "plus" and "minus" button. At step X1 the servo will move
between position A and B and the operation of "plus" and "minus" will result in slower or faster
movement of the servo.
Make sure that the position "centre" (X3) is always between position A and B. A position beyond position
A and B will result in the servo not working properly. The centre position of the servo is very important
for the ASB4 because the left and right deflection is measured with the centre position. If this position is
not programmed between the two strokes, the servo will go into a "loop" where it travels a path and
then returns to the beginning and repeats this. This is an indication that the centre position is not
properly set.
Resetting the ASB4
It may happen that programming did not go well or that you are not satisfied with the settings and want
to redo them. You can go through the steps again. However, you can also reset the entire ASB4.
This is done by pressing the PLUS and MINUS buttons simultaneously for 2 seconds in normal operation.
You will see the LEDs X1 to X4 light up briefly and the ASB4 is reset.
By the way, this does not work in PROGRAM mode to protect your settings.