domat UC010
08/2018 Subject to technical changes.
5
Short push to confirm the operation mode setting. The event time displays. Turn the
knob to set the time of the event and confirm by a short push. Then turn the knob to
select another event or long push and turn the knob to select another weekday.
After all desired events have been edited, long push to leave the time schedule settings.
The controller goes to the basic display mode also after 30 secs of user inactivity.
Change of setpoints and controller time:
Switch to the settings mode with a superlong push (>2.5 s). The controller switches to
settings mode (flashing thermometer icon).
Turning the knob selects between following settings:
-
Controller time and day of week (Clock icon, Day of week)
-
Setpoint temp. Heating Day mode (Temperature, Heating, Day are flashing)
-
Setpoint temp. Heating Night mode (Temperature, Heating, Night are flashing)
-
Setpoint temp. Heating Off mode (Temperature, Heating, Empty house are
flashing)
-
Setpoint temp. Cooling Day mode (Temperature, Cooling, Day are flashing)
-
Setpoint temp. Cooling Night mode (Temperature, Cooling, Night are flashing)
-
Setpoint temp. Cooling Off mode (Temperature, Cooling, Empty house are
flashing)
Select the requested value by a short push. Turn knob to change value. Confirm by a
short push again.
If there is no user activity for 30 s, the controller goes to the basic display mode.
Default values:
The default values as well as all other settings (PI parameters, address, baudrate...) can
be set by the configuration program, ModComTool.
Display
A large (60 x 60 mm) display clearly shows
actual room temperature and controller status
with 7-segment digits and standard Day, Night,
Off, and Time scheduler symbols. Active output
is indicated by a heating symbol. In the upper
part, there are week days used for time
scheduler setup. Other symbols are not used.
LCD symbol set
