
Rev 0–12 11 19
Fabriqué en Chine
Page 21
dePRession
on the upper part of the leg of the foot,
on one side there is a small horizontal
depression. and on the other side a
small horizontal opening too.
The side with the opening makes it pos
-
sible to screw the small locking screw
10.
The side with the depression allows the
tightening of the locking button 3.
snap the head support onto the top of
the foot, matching the holes to receive
the screw and the lock button.
imPoRtaNt!
Observe the following assembly order:
1. Pass the tilt adjustment bolt 4 through
the head and foot support. the
head of the tilt adjustment bolt has a
square: it must be embedded in the
support.
2. Screw the tilt lock knob 3.
3. Using a Phillips screwdriver, tighten
the small locking screw 10.
4. Screw in the tilt adjustment knob 11.
note: the 2 knurled knobs (3 and 11)
must be hand tightened.
dePRession
oPeninG
oPERatioN
1. Before using this appliance, place it
on a stable, dry surface.
2. Insert the power plug into a wall out
-
let.
3. turn the on/off button to select the
desired speed.
The air control speeds are as follows:
7- Low Speed
8- Medium speed
9- high speed
4. set the button to 0 to stop the device