Dolphin WAVE 100, Руководство по эксплуатации

Страница: 8 / 32

6) Auto mat ic s h ut down
The DDLPHIN WAVE 100 will automatically shut down after the cleaning cycle ends. Should another cycle be
required, switch off the power supply far at least 30 seconds before restarting.
The DDLPHIN WAVE 100 has an advanced computerized self protecting diagnostic mechanism. lt will automatically
shut off if it encounters a problem. The performance history of the DDLPHIN WAVE 100 is stored in its memory.
lt can be accessed by an approved DOLPHIN WAVE 100 service center only.
Caution: Surges and interruptions to electric power may cause the DDLPHIN WAVE 100 to restart.
SWITCH OFF THE POWER SUPPLY BEFORE REMOVING THE DOLPHIN WAVE 100 FROM THE POOL.
6.1) Remo val of OOLPHIN WAVE 100 from pool.
Ahe r the cycle time is completed SW/TCH OFF the power supply.
• Pull the DDLPHIN WAVE 100 to the surface by gently pulling the cable.
• When DDLPHIN WAVE 100 handle can be easily reached, grab the handle and turn the DDLPHIN WAVE 100
so that one of the brushes leans against the pool wall
[Fig E].
• Lift the DOLPHIN WAVE 100 out of the water by the handle only- NEVER BY THE CAB LE.
• By puling on the handle, lever the DOLPHIN WAVE 100 aver the pool edge, till it is lying on its side
[Fig
F] and
all the water has flowed out.
• Piace the DOLPHIN WAVE 100 upside down, release the 2 locking clips
[7 page-9] [Fig G]
and remove the
bottom lid assembly
[8 page-9] [Fig Hl
• Remove the 2 filter bag clips
[9 page-9]
and the filter bag
[10 page-9].
• Turn the filter bag inside out and wash thoroughly with a garden hose
[Fig I].
The bag may be laundered using a regular synthetic cycle. This should be done at least once every 2 months.
• Clean bottom lid i niet flaps, the springs and underneath the locking clips.
• Refit the filter bag with the tag on the outside positioned centrally along the length side of the bottom lid
[Fig
J ].
• Stretch the elastic trim of the bag aver the 2 metal frames and aver the lip of the bottom lid.
• Gather all the excess filter fabric into the center of the metal frames.
• Gather the fabric along the top of the frames so that the corners of the bag are adjacent to the corners of the
frames.
• lnstall a black filter bag clip aver the top of the frames
[Fig
J].
• lnstall the bottom lid assembly in the body and lock it in piace.
7) Per iod ica/ r e mava/
m ov i ng par ts (tracks,
o f debr is f r o m t h e
wh eel s, i m p el l er)
Warning! DISCONNECT MAINS BEFORE REMOVING IMPELLER TUBE [11 page-9]
• The impeller can be cleaned by twisting and removing the impeller tube
[Fig K].
• Remove debris or hair that has clogged the impeller
[12 page-9].
The impeller can be unscrewed by means of a Philips screwdriver.
• Remove the debris that has accumulated between tracks
[13 page-9]
and wheels
[14 page-9].
1_a�g __ _
6