30
0
31
0
S2
S1
30
0
31
0
S2
S1
30
0
31
0
S2
S1
310 MHz
310 MHz
- (8 dip switch)
300 MHz
- (10 dip switch)
- (10 dip switch)
4. SET DIP SWITCHES
a. Set the DIP switches of the keypad to match the DIP switch settings of the
receiver, or a functioning transmitter. (see Figure 4)
b. Enter then the 4 digit PIN on the keypad, and then press # to activate the
c. To change the 4 digit PIN (example)
receiver. If you just purchased the keypad, the factory default 4-digit PIN is 1234.
So please enter 1-2-3-4 #. If the receiver does not operate, reverse the keypad
DIP switches, and re-enter 1-2-3-4 #.
HINT: When you enter the correct code followed by #, the keypad LEDs flash slowly
for 5 seconds. If you enter an incorrect code, the keypad LED will glow steady for
5 seconds.
HINT: When you have entered the programming mode of # # the small LED glows
a steady red. When you complete the change of the PIN the small LED flashes
twice quickly.
To reset the keypad to the factory default code, remove the 9 volt battery and
depress and hold any key on the keypad, then reinstall the battery. Continue holding
the key down for 5 seconds and then release the key. The keypad is now reset to
the factory defaults.
Position the keypad on the garage door frame with the provided screws.
Lift up the conver and insert the long screw above the keypad in the slot
provided (a).
Remove the battery conver and insert the second long screw in the
lower slot (b).
Replace the battery cover.
# # 1-2-3-4
1-3-5-7 #
(Old Pin)
followed within 5 seconds by
(New PIN)
pin must be four digits
300
M
H
Z
310
M
H
Z
S2
S1
Back
Opening
Back of
Keypad
a. Remove the access door on the top back of the keypad by sliding the door
in the direction of the arrow. (see Figure 1)
b. Locate the frequency switches on the top of the electronic board located
inside of the access door. (see Figure 2)
3. SET FREQUENCY JUMPER
a. Determine the operating frequency you will use on your keypad installation.
This keypad can operate at either 300 MHz or 310 MHz. At 300 MHz the keypad is
compatible with the Hive 300/310 receiver and all 300 MHz receivers with 10 dip
switches. At 310 MHz the keypad is compatible with the Hive 300/310 receiver,
and all 310 MHz receivers with 8 dip switches and 310 MHz receivers with 10 dip
switches. (see S1 and S2 on Figure 3)
4
3
3
Figure 3
Figure 1
Figure 2
Figure 4
jumper
in place
access
door
dip
switches
300
M
H
Z
310
M
H
Z
S2
S2
S1
310MHz
8 dip
10 dip
dip
switch
selection
jumper
300MHz
cover
