English
Operation
- 16 -
show the last programmed memory channel. If no memory channels have been
programmed, radio will return automatically to Stand-by mode.
3. Shortly press the MENU (8) key and the UP (5) or DOWN (7) keys to select the desired
memory channel e press the PTT (15) key to confirm the selection.
4.
To exit the MEMORY MODE switch OFF and ON the radio.
Memory Channels Delete
1. Recall the desired memory channel as indicated above.
2.
Press and hold the MENU (8) key for about 3 seconds until the M (S) icon will blink on the
LCD display.
3.
Press the UP (5) or DOWN (7) keys to select the memory channel
0
and press the PTT
(15) key to confirm the deletion. The radio will enter in Stand-by mode.
AUTOMATIC SCAN
This function allows automatic scanning of all channels and programmed memories. To start
the automatic scan function proceed as follows :
Automatic Channel Scanning
1. Shortly press the SCAN (14) key; the unit will automatically start the automatic channels
scanning and the SC (O) icon will appear on the LCD display.
SCAN will automatically stop when a signal is detected on one channel, in order to listen to
the communication and SCAN will re-start when no more signal is detected on that channel
after about 4 seconds. If you press the PTT key (15) during the SCAN operation, SCAN will
stop automatically and radio will set the last used channel. SCAN will then restart after
about 14 seconds if no signals are received on that channel. If a signal with a CTCSS code
is received, the radio shows that channel with the corresponding code. If the receiving code
is different from the pre-programmed, the radio won’t correspond with that correspondent.
2.
Press the SCAN (14) key to exit the SCAN mode.
Automatic Memory Channels Scanning
1. Press and hold the MENU (8) key for about 3 seconds to enter the MEMORY MODE. The
M icon (S) will blink on the LCD display.
2. Shortly press the PTT (15) key to enter the MEMORY RECALL MODE. The radio will
show the last programmed memory channel.
3. Shortly press the SCAN (14) key; the unit will automatically start the automatic memory
channels scanning and the SC (O) icon will appear on the LCD display.
