Dolphin DAS400, Руководство пользователя, Страница: 8 / 16

8
This diagram is for fitting 6 Micro
sensors at the front of the car with
either a buzzer, 600F, or dashboard
display, 650F.
The Micro sensors have a slight angle
moulded into them and should be fitted
to face slightly up. The outer sensors
A and F are less sensitive and are
designed to be mounted on the sides of
the bumper to cover the covers with the
middle sensors B – E covering the rear.
The 600F/650F is supplied with longer
6m sensors to fit around the engine
bay. The sensor cabling should be run
down the opposite side of the engine
bay to where the battery is situated to
avoid electrical interference. The Brain
box should be mounted underneath
the dashboard but away from the fuse
box and anything else likely to cause
electrical interference.
A rocker switch is supplied for you to
manually turn the front sensors on as
and when you need them. This should
be connected to an ignition switched
feed, that is a power source that is live
when the car is on, such as the car
stereo system. Alternatively you may like
to visit your local car dealerships’ parts
department to get a blank switch that
matches the design of the others on
your dashboard.
Optionally if you have a modern CANBus
wired car you may have additionally
purchased (or can purchase, see Spares
& Accessories) a CANBus interface
that will take a speed reading for
the cars engine management system
and automatically bring the sensors
on whenever your speed is below
approximately 6mph.
INSTALLATION OF 6 SENSOR FRONT KIT DMS 600F/650F