Dolmar WD-2035, Инструкция по эксплуатации

Страница: 15 / 62

UK
- 15 -
3
.... TO CLEAN UP LARGE AMOUNTS OF LIQUID (fig. “C1”)
- To ensure a partial air flow, do not fully immerse the crevice tool when large
amounts of liquid are sucked up from containers.
4
.... USE OF THE ELECTRIC POWER TOOL - VACUUM CLEANER
(fig. “C2” - “C3” - “C4”)
- Always fit the filter cartridge.
- Remove the sponge filter if installed.
ATTENTION: To ensure that the appliance works efficiently, always keep the filter cartridge clean.
It is advisable to replace the cartridge after about 100 hours service.
- Fit the sleeve (M) of the hose pipe (code 668 001 321) into the air inlet union (Y) (fig. “C2”)
and the universal adapter (U) into the conveyor of the electric power tool (fig. “C3”).
- Plug in the electric power tool and the appliance as described in point “A3”.
- Using the clamps (G), fix the electric cable of the electric power tool to the hose pipe (fig.
“C4”).
- Set the switches in the positions described in point “A2”.
-------------------------------------------------------------------------
D - MAINTENANCE
Always remove the plug from the electricity
main before proceeding with any maintenance operation.
1
.... DUST BAG pack code 668 083 134
- The bag cannot be reused. It must always be replaced.
How to change the dust bag.
-
Remove the plastic flange (X) from the air inlet union (Y) of the vacuum cleaner (fig. “D1”).
- Take the filter paper bag out of the container-drum (fig. “D2”).
- Close the plastic flange with the relative plug (fig. “D3”).
2
.... FILTER CARTRIDGE pack code 668 083 201(fig. “D4” - “D5”)
- Remove the filter cartridge from the motor support.
- Clean the filter cartridge frequently using a soft bristle brush (fig. “D4”).
- To clean more thoroughly, use a shower fitting and direct the jet of water from the inside
towards the outside of the filter cartridge (fig. “D5”).
- Make sure that the filter cartridge is perfectly dry before using it again.
- If the filter cartridge is heavily caked or worn, replace the filter element only (b).
3
.... SPONGE FILTER code 668 083 035 (fig. “D6”)
- Rinse the sponge filter under running water WITHOUT using detergents.
- Replace the sponge filter if it is torn or worn.
4
.... P.P. BASKET PRE-FILTER code 668 083 100 (fig. “D7”)
- Shake the dirt from the basket pre-filter into a waste bin.
- Blow it clean with compressed air if necessary.
- Replace the basket filter if it is torn or worn.